Double Stage Drive System for Induction Motor Based on Direct Axis Current Control
Keywords:
Td (develop torque), E1 (stator voltage), Ns (Synchronous speed), Nr (rotor speed), fs (stator supply frequency), Id (direct axis current), Iq (Indirect axis current).
Abstract
This paper deals with double stage drive system of 3-phase induction motor. As 3-phase induction motor consider as load thus its speed and torque at output shaft counts as performance parameter. One of these two stages is to control over DC voltage use to fed in inverter set provide controlling over output shaft torque. A feedback signal of torque generate error signal of PID controller which control output voltage level of phase control rectifier. This controlled voltage is fed to inverter where another stage comes into existence. Conversion of 3 to 2 phase of load current use as feedback signal for this stage of controlling. Another PID controller is use to control direct axis current of output supply of inverter. This 3-phase controlled output of inverter is fed to the armature winding of 3-phase induction motor by which controlling over speed will achieve. Simulation result will show the effect of this two stage controlling technique in the performance of 3-phase induction motor.Downloads
Download data is not yet available.
Published
2014-06-25
Section
Research Articles
Copyright (c) 2014 SAMRIDDHI: A Journal of Physical Sciences, Engineering and Technology
![Creative Commons License](http://i.creativecommons.org/l/by-nc-nd/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.